GOLD - Black Mark (20W) Laser Settings - Fiber 20W

Specifications and context

Evidence status

Bundled baseline — no community vouch or proof-burn photo attached

Source data reviewed

2026-08-09

Laser source

Fiber (MOPA)

Model

Fiber 20W

Power

34%

Speed

750 mm/s

Frequency

200 kHz

Passes

1

Hatch interval

0.002 mm

Pulse width

Not specified

Production guidance

This GOLD - Black Mark (20W) metal record pairs 34% power with 750 mm/s on Fiber 20W, using 1 pass, 200 kHz, 0.002 mm hatch spacing, and no recorded pulse-width override. Compare every listed field with the source, lens, focus method, and material finish on your machine before transferring the recipe.

1. 1. Oxidized black contrast mark on gold surface.
2. 2. Treat this as an unverified baseline, not a production preset. A VERIFIED Parameters Library record requires three independent community vouches; an attached proof-burn image provides additional evidence.
3. 3. Bare metal is unforgiving of focus error: re-zero on the actual work surface rather than the bed, and wipe oils off before marking or the mark will read blotchy.
4. 4. MOPA pulse width is the parameter doing the work here — if the result drifts, adjust pulse width before touching power or speed.
5. 5. A 0.002 mm hatch is fine enough that overlap error shows: verify the galvo or gantry is square before running a large field.
6. 6. Record the successful result in the Parameters Library so the next production run is repeatable.

The bundled note for this GOLD - Black Mark (20W) recipe is: “Oxidized black contrast mark on gold surface.” The source data was reviewed 2026-08-09; no independent vouch or proof-burn image is attached. Label the scrap test with the adjusted values and keep the accepted result with the production job.