POLYESTER - Mark (20W) Laser Settings - Fiber 20W

Specifications and context

Evidence status

Bundled baseline — no community vouch or proof-burn photo attached

Source data reviewed

2026-08-09

Laser source

Fiber (MOPA)

Model

Fiber 20W

Power

34%

Speed

750 mm/s

Frequency

45 kHz

Passes

1

Hatch interval

0.025 mm

Pulse width

Not specified

Production guidance

This POLYESTER - Mark (20W) other record pairs 34% power with 750 mm/s on Fiber 20W, using 1 pass, 45 kHz, 0.025 mm hatch spacing, and no recorded pulse-width override. Compare every listed field with the source, lens, focus method, and material finish on your machine before transferring the recipe.

1. 1. Surface marking on polyester material.
2. 2. Treat this as an unverified baseline, not a production preset. A VERIFIED Parameters Library record requires three independent community vouches; an attached proof-burn image provides additional evidence.
3. 3. Unlisted substrates vary batch to batch. Treat these numbers as a starting point and step power in small increments rather than jumping to the listed value.
4. 4. MOPA pulse width is the parameter doing the work here — if the result drifts, adjust pulse width before touching power or speed.
5. 5. Change one variable at a time — power, then speed, then frequency — so you can attribute the improvement when you find it.
6. 6. Record the successful result in the Parameters Library so the next production run is repeatable.

The bundled note for this POLYESTER - Mark (20W) recipe is: “Surface marking on polyester material.” The source data was reviewed 2026-08-09; no independent vouch or proof-burn image is attached. Label the scrap test with the adjusted values and keep the accepted result with the production job.