POWDER COATED TUMBLER - Engrave Laser Settings - Fiber 50W

Specifications and context

Evidence status

Bundled baseline — no community vouch or proof-burn photo attached

Source data reviewed

2026-08-09

Laser source

Fiber (MOPA)

Model

Fiber 50W

Power

80%

Speed

1500 mm/s

Frequency

30 kHz

Passes

1

Hatch interval

0.025 mm

Pulse width

Not specified

Production guidance

This POWDER COATED TUMBLER - Engrave coated record pairs 80% power with 1500 mm/s on Fiber 50W, using 1 pass, 30 kHz, 0.025 mm hatch spacing, and no recorded pulse-width override. Compare every listed field with the source, lens, focus method, and material finish on your machine before transferring the recipe.

1. 1. Tumbler marking. Rotary axis required.
2. 2. Treat this as an unverified baseline, not a production preset. A VERIFIED Parameters Library record requires three independent community vouches; an attached proof-burn image provides additional evidence.
3. 3. Coating thickness is the real variable. Apply evenly, let it cure fully, and re-test whenever you change spray batch or application method.
4. 4. MOPA pulse width is the parameter doing the work here — if the result drifts, adjust pulse width before touching power or speed.
5. 5. Change one variable at a time — power, then speed, then frequency — so you can attribute the improvement when you find it.
6. 6. Record the successful result in the Parameters Library so the next production run is repeatable.

The bundled note for this POWDER COATED TUMBLER - Engrave recipe is: “Tumbler marking. Rotary axis required.” The source data was reviewed 2026-08-09; no independent vouch or proof-burn image is attached. Label the scrap test with the adjusted values and keep the accepted result with the production job.