STAINLESS STEEL 304 - MOPA Color (Green) Laser Settings - JPT M7 60W

Specifications and context

Evidence status

Bundled baseline — no community vouch or proof-burn photo attached

Source data reviewed

2026-08-09

Laser source

Fiber (MOPA)

Model

JPT M7 60W

Power

25%

Speed

1000 mm/s

Frequency

350 kHz

Passes

1

Hatch interval

0.001 mm

Pulse width

15 ns

Production guidance

This STAINLESS STEEL 304 - MOPA Color (Green) metal record pairs 25% power with 1000 mm/s on JPT M7 60W, using 1 pass, 350 kHz, 0.001 mm hatch spacing, and 15 ns pulse width. Compare every listed field with the source, lens, focus method, and material finish on your machine before transferring the recipe.

1. 1. Green color. Requires fine line spacing.
2. 2. Treat this as an unverified baseline, not a production preset. A VERIFIED Parameters Library record requires three independent community vouches; an attached proof-burn image provides additional evidence.
3. 3. Bare metal is unforgiving of focus error: re-zero on the actual work surface rather than the bed, and wipe oils off before marking or the mark will read blotchy.
4. 4. MOPA pulse width is the parameter doing the work here — if the result drifts, adjust pulse width before touching power or speed.
5. 5. A 0.001 mm hatch is fine enough that overlap error shows: verify the galvo or gantry is square before running a large field.
6. 6. Record the successful result in the Parameters Library so the next production run is repeatable.

The bundled note for this STAINLESS STEEL 304 - MOPA Color (Green) recipe is: “Green color. Requires fine line spacing.” The source data was reviewed 2026-08-09; no independent vouch or proof-burn image is attached. Label the scrap test with the adjusted values and keep the accepted result with the production job.