TITANIUM GRADE 2 - Color Mark (Golden Yellow) Laser Settings - Fiber 30W MOPA

Specifications and context

Evidence status

Bundled baseline — no community vouch or proof-burn photo attached

Source data reviewed

2026-08-09

Laser source

Fiber (MOPA)

Model

Fiber 30W MOPA

Power

20%

Speed

800 mm/s

Frequency

100 kHz

Passes

1

Hatch interval

0.01 mm

Pulse width

30 ns

Production guidance

This TITANIUM GRADE 2 - Color Mark (Golden Yellow) metal record pairs 20% power with 800 mm/s on Fiber 30W MOPA, using 1 pass, 100 kHz, 0.01 mm hatch spacing, and 30 ns pulse width. Compare every listed field with the source, lens, focus method, and material finish on your machine before transferring the recipe.

1. 1. Golden-yellow TiO2 thin oxide. Source: Jimani Inc. titanium oxide application guide (2024).
2. 2. Treat this as an unverified baseline, not a production preset. A VERIFIED Parameters Library record requires three independent community vouches; an attached proof-burn image provides additional evidence.
3. 3. Bare metal is unforgiving of focus error: re-zero on the actual work surface rather than the bed, and wipe oils off before marking or the mark will read blotchy.
4. 4. MOPA pulse width is the parameter doing the work here — if the result drifts, adjust pulse width before touching power or speed.
5. 5. A 0.01 mm hatch is fine enough that overlap error shows: verify the galvo or gantry is square before running a large field.
6. 6. Record the successful result in the Parameters Library so the next production run is repeatable.

The bundled note for this TITANIUM GRADE 2 - Color Mark (Golden Yellow) recipe is: “Golden-yellow TiO2 thin oxide. Source: Jimani Inc. titanium oxide application guide (2024).” The source data was reviewed 2026-08-09; no independent vouch or proof-burn image is attached. Label the scrap test with the adjusted values and keep the accepted result with the production job.