Make an EZCAD Test Card (DXF + Pen CSV) for Fiber Lasers

Watch the 1:54 EZCAD Test Card Export tutorial, recorded on the live site, with a step-by-step PDF guide and a link to open the tool. Free to watch.

Make an EZCAD Test Card (DXF + Pen CSV) for Fiber Lasers video thumbnail — Video: Make an EZCAD Test Card (DXF + Pen CSV) for Fiber Lasers (1:54) — PDF guide · Open EZCAD Test Card Export

In this tutorial

Across (columns): speed 200–1200 mm/s over 6 columns by default
Down (rows): power 20–100% over 5 rows; any two parameters, up to 30 cells
Held constant on every cell: frequency, pulse width, passes, line interval and Z defocus
Card geometry: cell size and the gap between cells, in mm
The summary line, and Reset to the default sweep
EXPORT EZCAD TEST CARD (DXF + CSV): two downloads
Inside the files: PEN_00 to PEN_29 in the DXF; CSV pens start at 0 to match
The LABELS layer marks too, unless you turn that pen off or delete the labels
How the handoff works: import, key the pens, burn on scrap, read the best cell

Chapters

0:00 Intro
0:14 Across (columns)
0:32 Held constant on every cell
0:46 Read it back
0:56 Export EZCAD test card
1:06 Inside the files
1:22 The LABELS layer
1:42 Wrap-up

What the EZCAD Test Card Export tutorial covers

0:14 — Across (columns)
0:32 — Held constant on every cell
0:46 — Read it back
0:56 — Export EZCAD test card
1:06 — Inside the files
1:22 — The LABELS layer

Find the Right Laser Tool for Your Job See Real Results →

Privacy Policy| Terms of Service| Refund Policy| Contact and Support